Bateau Corsair 13 - March 21

Took leave today to attend my daughter's first graduation. The cermony finished just before lunch so after a nice celebration lunch I had a few hours to work on the boat.

Decided to improve a few of the fillets. Some just did not feel right - too wide, too shallow. Trimmed the seat supports at the transom so I can lay a full width fiberglass seam on the vertical transom edge. I think joint strength will be more important. I can replace the small batten peice later. Wasn't able to glass these joints though becuase we ran out of the "tape" we'd cut from the cloth.

Glassed the inner joints between the transom and the bottom panels. Put 5 layers of the 6oz cloth. Was also able to glass the keel, also with 5 layers, between frames C and D.